Construction estimating services in Pompano Beach, FL

According to the U.S. Census Bureau Building Permits Survey, the city issued permits for 356 new privately-owned residential units in 2025, up from 314 in 2024, a 13 percent increase. Of those, 73 were single-family and 283 were multifamily, so 79 percent of permitted units were multifamily. The permitted value was about $40 million, or roughly $112,000 per unit. These figures count new privately-owned residential units only, not commercial or renovation permits, so they understate total construction activity in the city.

Most projects return in 24 to 48 hours, and rush turnaround is available when you have a bid date inside that window. Turnaround depends on the completeness of the set, so send the full architectural, structural and MEP drawings plus any addenda in one package. If the set is issued in phases, tell us which sheets are still pending so we can flag the quantities that are likely to move. Deliverables come back in Excel and PDF, organized by CSI MasterFormat division, with the plan set marked up.

The unit counts and permitted value on this page come from the U.S. Census Bureau Building Permits Survey for 2025, with 2024 shown for comparison. The survey counts permits issued by the city itself for new privately-owned residential units only. It excludes commercial permits, additions, alterations and demolitions, and it does not capture unpermitted work. For that reason you should treat the numbers as a demand signal for residential work in Pompano Beach, not as a measure of total construction volume in the city.

Salt air and wind-driven rain push up the specification on roofing, waterproofing, fasteners and exterior coatings, and those items are measured separately rather than absorbed into a generic square-foot rate. Wind uplift requirements change the fastener count and the attachment method on roof assemblies. The shallow water table adds dewatering and often muck excavation to the sitework scope. We carry each of these as its own line so you can see what the coastal exposure is actually costing you instead of guessing.

Yes. Multifamily is the dominant permitted product in Pompano Beach, so most of our local work is podium and mid-rise. We measure per-unit scope for the residential floors, then carry the shared back-of-house scope separately, which keeps the unit cost comparable across floor plates. Fire protection, duct routing and plumbing stacks in podium ceilings are the usual coordination problems, so we flag those in the takeoff notes. Our multi-family estimating service covers the full division set.

Send the complete drawing set by discipline, any addenda, and the specification book if one is issued. A geotech report is important on Pompano Beach jobs because it drives the foundation scope. If you have a bid form or a required scope breakdown, send that too, since it determines how we structure the spreadsheet. Tell us the bid date so we can sequence the work. You can start the process on our get an estimate page.

We price with ZIP-code-adjusted material and labor rates using RSMeans data, so Broward County wage and material costs are reflected rather than a national average. That matters on trades where local labor is tight, such as concrete finishing and MEP rough-in. Quantities come from the drawings using Bluebeam Revu and PlanSwift, and the pricing layer is applied after the quantities are checked. If you have current quotes from your own subs, send them and we can compare them against the database rates.

Yes, and on flat coastal sites we usually recommend it. Sitework quantities come off the civil set, not the architectural set, and the two are often issued on different dates. We measure clearing, stripping, muck excavation, fill, grading, exfiltration and storm piping as separate lines so the earthwork bid can be carried by a site contractor without the building scope attached. If the civil set is not ready, we can start the building trades and add sitework later.

Send the revised sheets and the addendum number, and we will re-measure the affected scope and mark the changes against the original takeoff. Keeping the two versions side by side is what makes the revision useful during bid leveling, since you can see exactly which quantities moved. If the change is limited to one trade, we only re-run that division. Larger changes, such as a switch from wood frame to light-gauge steel, are treated as a new takeoff because the measurement method changes.

Yes. We cover the rest of Broward County and South Florida, including nearby cities such as Boca Raton, Davie and Miami Gardens, as well as West Palm Beach, Clearwater and Lakeland. Rates are adjusted by ZIP code, so a job in one of those markets prices differently from one in Pompano Beach even when the drawings are identical. If you have work across several markets, send the sets together and we can return a comparison. The Florida construction estimating page covers our statewide coverage.